Here is the steering stick out of the hovercraft and without the throttle on it.

Here it is in the hovercraft with the throttle on it.

Here it is with the seat covers on.

Here is the cable that will pull the trim wing up, on the back of the control arm there is a spring which pulls it down. The cables that we have on in these pictures are temperary. They are just some plastic coated steel cable that we had left over from our pool cover, we didn't want to cut our good stainless steel cable wrong and mess it up so we will cut these cables to lenght then cut the stailess cables to match these. We will also keep the temperary cables for extras.

Here is the pulley that the cable bends around to the trim wing.

Here is another pulley that the trim wing cable bends around and then it goes to another pulley in the center of the hovercraft just behind the seat.

Here is the trim wing cable that is just behind the seat.

Finally here is where the trim wing cable connects to the steering stick.

Here is the steering stick.

Here is the steering stick with the plywood over the belt gaurd.

There is only one cable for steering, It goes from one side of the rudders through the cockpit then to a pulley and on to the steering stick and it gets connected to it, as shown in this picture, then it goes to another pulley then out of the cock pit and to the other side of the rudders.